RightAngle Reference Manual

  • Welcome to RightAngle Control
  • Introduction
    • User Interface
    • Gauging
    • Tools
    • General panels
    • Application notes
      • Selection of Tools
      • Air bending
      • Large Radius Bending
      • Hemming
      • Coining
  • Home
  • Create
    • From Profile
      • Profile Selection
      • Create/Edit a Profile
      • Extrude
    • Fold Flat DXF
      • Main Screen
      • Create
      • Edit
      • Fold
    • Import 3D model
      • Main screen
      • Unfold
      • Do Tooling
    • Direct Programming
      • Main Screen
      • Add/Remove
      • Settings
      • Run
      • Navigate Bend
      • Corrections
      • Jog
      • Table Programming
    • Setting page
    • Create Tool
  • Edit
    • Sequence
    • Back gauges
    • Tooling
    • Simulation
  • Run
    • Main Screen
    • Model Based WF
      • Setup Sheet
      • Run Program
    • Program Based WF
      • Info Screen
      • Run
    • Corrections
    • Edit Cycle
  • Settings
    • Jog Axes
    • Manual Program
    • Tool Inventory
    • Other Settings
  • Feature list
    • Angle Measurement System (Pre-release)
      • IRIS Plus (Pre-release)
  • Tandem Operation
    • Operation
    • Communication Error
  • Impressum
  • FAQs
    • Licensing
Impressum

Impressum

Corporate Information

Vendor of the website
TRUMPF Werkzeugmaschinen SE + Co. KG
Johann-Maus-Straße 2
71254 Ditzingen
Germany
Phone +49 7156 303-0
Fax +49 7156 303-930309
E-mail info@TRUMPF.com

Management:
Dr.-Ing. Stephan Mayer
Dr.-Ing. Thomas Schneider
Dipl.-Wirt. Ing. Till Küppers
Marcella Montelatici

Amtsgericht Stuttgart (local court) HRA 202772
VAT Identification No. DE 813 103 015
PhG TMT SE, based in Ditzingen
Amtsgericht Stuttgart (local court) HRB 778168

Data privacy notice

The information in accordance with Article 13 GDPR on how your data are handled in our company can be found on our homepage https://www.TRUMPF.com/en_INT/meta/dataprivacynotice.

Copyright and Trademarks

All texts, pictures, graphics, animation, videos, sounds and any other contents of this website and their layout are protected by copyright and other protective laws. The afore-mentioned contents may not be duplicated, modified or used in other electronic or printed publications without the prior consent of TRUMPF Werkzeugmaschinen SE + Co. KG.

All patents, trademarks and works protected by copyright which are presented on this website are the intellectual property of TRUMPF SE + Co. KG unless otherwise stated. This applies in particular for TRUMPF trademarks, logos, emblems and name plates.

Contents

  • Corporate Information
  • Data privacy notice
  • Copyright and Trademarks
Communication Error FAQs

      Copyright © 2025 TRUMPF Metamation. All rights reserved.

    Compiled by Bento