Bend Cycle
Speed
Slow down speed percent
Range |
1-100 |
Default |
100 |
Units |
% |
Access |
Administrator |
Function
Default slow down speed percentage of fast closing ram speed when no data is entered in bend time line cycle.
Description
NA
BDC speed
Range |
1-100 |
Default |
100 |
Units |
% |
Access |
Administrator |
Function
Percentage of bending speed with which ram moves during bending when no data is entered in bend timeline cycle.
Description
NA
Release speed
Range |
1-100 |
Default |
100 |
Units |
% |
Access |
Administrator |
Function
Percentage of bending speed with which ram moves during decompression phase when no data is entered in bend timeline cycle.
Description
NA
Back Gauge speed
Range |
1-100 |
Default |
100 |
Units |
% |
Access |
Administrator |
Function
Percentage of BG speed with which back gauge moves.
Description
NA
Distance
Slow down position from pinch point
Range |
1-999 |
Default |
10 |
Units |
mm |
Access |
Standard |
Function
Default value of mute position when no data is entered in bend timeline cycle.
Description
NA
UDP position from pinch point
Range |
10-999 |
Default |
100 |
Units |
mm |
Access |
Standard |
Function
Default distance ram should move from pinch position during opening when no data is entered in bend timeline cycle.
Description
NA
Pinch adjust
Range |
-1 to 1 |
Default |
0 |
Units |
mm |
Access |
Function
Description
Limit
Pinch adjust limit
Range |
0.5 to 2 |
Default |
1 |
Units |
mm |
Access |
Administrator |
Function
This parameter is not used for now.
Description
Two angle correction bend length limit
Range |
500-3000 |
Default |
1000 |
Units |
mm |
Access |
Administrator |
Function
Minimum bend length required for activation of two angle correction.
| If two angle correction is activated for smaller bend length, result may vary considerably as two angle correction is intended for longer bend length. |
Description
NA
Three angle correction bend length limit
Range |
500-3000 |
Default |
1000 |
Units |
mm |
Access |
Administrator |
Function
Minimum bend length required for activation of three angle correction.
| If three angle correction is activated for smaller bend length, result may vary considerably as three angle correction is intended for longer bend length. |
Description
NA
Time
Dwell time
Range |
100 to 5000 |
Default |
100 |
Units |
ms |
Access |
Administrator |
Function
Default dwell time after bending when no data is entered in bend timeline cycle.
Description
NA